Professional diamond cutter 5.0 mm

  • Professional cutter with diamond surface and truncated cone-shaped tip
  • Suitable for gently lowering and abrading the nail surface and reducing the length of the nails
  • Autoclavable
  • Diameter 5.0 mm
Ref: CM660



Log in to visualise prices and purchase

Prices on Tecniwork.it are visible after logging into the website reserved to professionals only.

Purchase securely

Thousands of satified customers

Quick delivery

in 2/3 working days
Product description

Professional bi-directional stainless steel micromotor cutter with diamond surface and truncated cone-shaped tip.

Suitable forgently lowering and abrading the nailsurface and reducing nail length .

The working part is covered with high-grade diamond grains, aggregated with a special process that guarantees a surface with a homogeneous and long-lasting distribution, for excellent working results.

Made of hygienic stainless steel and easily disinfected and sterilised up to 180°C: in an autoclave, with dry heaters or chemical solutions.


1 pc

Details

Diameter: 5.0 mm

Recommended operating speed: 1,000 to 40,000 rpm

Hints

Correct hygiene:


Spray with Ref. CP709, ENZIMASEPT SPRAY, ready-to-use instrument pretreater and wait at least 5 minutes.

Never use abrasive metal brushes for cleaning.

Rinse and proceed with simultaneous cleaning, cleansing and disinfection with Ref. CP708 ENZIMASEPT, concentrated disinfectant detergent, which must be diluted in water and can be used in ultrasonic equipment.

Contact time with instruments is 10 minutes, maximum 15 minutes, after which rinse thoroughly with demineralised water and dry.

Proceed with the usual sterilisation techniques (autoclave etc.).

Caution: do not use temperatures higher than 180°C.


For a better abrasive performance, we recommend cleaning the diamond burr with the specific silicon carbide stone, Ref. CM406; this is a fine-grained white stone which should be moistened with water before gently sliding the burr over its surface.

Back to start